Ford Transit Upfitter Switch Guard (3D Print File)

Print Settings

Filament

Interior vehicle components exposed to direct solar radiation can get extremely hot (up to 90°C per ISO 16750-4), so using a filament with high temperature resistance is recommended:

• PETG/PC Blend (110°C temperature resistance).
  • Tip for this filament: print outer walls slowly below 60mm/s for a better-looking (uniform) finish.
• ASA (100°C temperature resistance).
• PC (116°C temperature resistance).

Print Settings

Here are the recommended print settings (settings not listed are up to your discretion):

• Variable layer height from 0.2mm (bottom) to 0.08mm (top). See photo below.
• 3 Wall loops.
• 15% infill, except 100% infill from 17.00mm to 18.5mm (for strength).
• With support:

The Transit Upfitter Auxiliary Switches are located between the passenger/driver seat, and they’re very easy to catch and accidentally turn ON/OFF. We constantly catch them with our knees when going from the front cabin to the living area in our van. It’s also a common complaint from people with dogs.

Our Upfitter Auxiliary Switch Guard prevents from accidentally flipping the switches and protects them from damage (notably when rotating the passenger swivel seat):

The Upfitter Switch Guard is reversible, you’ve got a few options:

1. No text:

2. Use a P-Touch with 1/2″ (12mm) tape to add your own text:

Installation

The Guard is attached with 3M VHB Tape (0.375 in width). Clean the surfaces to be bonded with Isopropyl alcohol, peel-off the release liner and apply pressure to the surfaces for 5-10 seconds:

Compatibility

Fits Ford Transit years 2020 to present.

Specifications

• Dimensions: 4.2in x 2.4in (106mm x 60mm).
• Compatibility: Ford Transit 2020 to present.
  • The contact surface is curved on pre-2020 Transit and therefore the guard won’t fit.

No 3D Printer?

That’s OK, we can 3D print it and ship it to you. Please use our physical product page: